|
|
How to properly set up and operate your
SCBA Ultrasonic Cleaning System
1. Make sure you have all the cleaning system components with the product list
enclosed in the shipping carton.
2. Fill the tank of the SCBA Ultrasonic Cleaning System approximately 2/3 full.
Use the proper ratio of water and SCBA Ultrasonic Cleaner Concentrate, following
the instructions on the label.
3. Perform a field level disassembly. Place mask into the stainless steel rack
so that it will not entrap air, and insert into ultrasonic cleaning machine. Set
timer to initiate the cleaning cycle. The machine will automatically shut off
at the end of the cleaning cycle.
4. When the cleaning cycle ends, remove rack. Rinse thoroughly under running water.
After rinsing, begin drying or disinfect as usual. Reassemble and check for function
as per the manufacturer's instructions.
Note: Radio communication devices should not be placed into the machine. Regulators
must be cleaned by certified personnel as per the manufacturer's instructions.
This Ultrasonic Cleaning System supplements your field level maintenance. Follow
your manufacturer's instructions carefully. When in doubt, always refer to the
manufacturer's instructions. |
 |
 |